Just getting around to all the minor finishing jobs that need doing. Fitted a front number plate which makes the car seem finished now, as well as a...
Yes 3D printers can be addictive. I bought one a few years ago and have used it to print raised lettering for signs that I make. It's a small bed so...
Wheeler Dealers once built a beach buggy. It was going to be a Beetle restoration but the car was too far gone so Ed decided to turn it into a beach...
I hadn't forgotten Alistair - It's on my latest (relatively small) list of Jobs to finish the car off. The biggest single item of expenditure will be...
Dismantled the side that was sitting low (n/s) and couldn't find anything untoward so adjusted the spring plate to raise the car by about an inch and...
Jim's solution is ideal for my car. I can remove the bonnet without having to unplug piping everytime and the routing of the pipework was simplicity...
It shouldn't need it due to the age of the car (1967) but would be easy enough to install should needs be - however I like the look of the rear with...
I have two identical sets of Hydraulic rams. Whilst all operate normally they don't maintain the negative hold down pressure for any length of time....