Tab Content
  • Brett's Avatar
    21-10-2020, 05:47 PM
    There was a discussion going on about servo(power assist)brakes. Whether or not are cars need them. I sat back and listened to the discussion but...
    5 replies | 88 view(s)
  • Brett's Avatar
    19-10-2020, 07:30 PM
    I guess one thing that I don't understand is why the starter would be getting any voltage at all with the key in the "on" position. The only time the...
    679 replies | 91874 view(s)
  • Brett's Avatar
    19-10-2020, 01:12 PM
    Brett replied to a thread 009 in Your Cars
    Location was determine after experimenting with several different sets of equal length tie rods and getting the best angle to the steering arms to...
    200 replies | 25327 view(s)
  • Brett's Avatar
    19-10-2020, 01:29 AM
    By voltage drop are you saying that half the car has full voltage and the other half is only getting 9.5 with the ignition in the on position with...
    679 replies | 91874 view(s)
  • Brett's Avatar
    19-10-2020, 01:18 AM
    Brett replied to a thread 009 in Your Cars
    Used the Subaru back splash fitting Flaps move freely so it has to be mounted horizontally to work properly. Picture of it open Picture of it...
    200 replies | 25327 view(s)
  • Brett's Avatar
    19-10-2020, 01:10 AM
    Brett replied to a thread 009 in Your Cars
    Hi Peter I check the site a couple of times a day Still working on the car, just haven't had any motivation to post. Been working on the...
    200 replies | 25327 view(s)
  • Brett's Avatar
    10-10-2020, 02:02 AM
    Before you spend money on a starter have the battery tested under a load. Just putting a volt meter on the battery is not good enough. That will...
    679 replies | 91874 view(s)
  • Brett's Avatar
    10-10-2020, 12:35 AM
    4-2 gauge wire is used for a starter. Starter bushing could be worn out(replace if bad), also the starter could be bad. works with no load but...
    679 replies | 91874 view(s)
  • Brett's Avatar
    09-10-2020, 10:45 AM
    I haven't been following this build so maybe this has already been suggested. If you already have the ends but they are on separate shafts why not...
    798 replies | 109695 view(s)
  • Brett's Avatar
    08-10-2020, 11:57 PM
    This company says they can make it. of course price for making just one may put it out of reach. https://www.hayescouplings.com/splined-adapters/...
    798 replies | 109695 view(s)
  • Brett's Avatar
    07-10-2020, 01:00 AM
    Brett replied to a thread Pog's sterling.... in Your Cars
    Motor is bolted directly to the mounting bracket with no adjustments. You would have to shim up the whole wiper assembly to get the pivot shaft...
    581 replies | 88822 view(s)
  • Brett's Avatar
    05-10-2020, 10:30 PM
    Brett replied to a thread Pog's sterling.... in Your Cars
    I don't recall having to use any spacers. Thats alot of space that needed adjustment Here are the dimensions of my old parts. as far as I know I...
    581 replies | 88822 view(s)
  • Brett's Avatar
    02-10-2020, 03:15 AM
    Brett replied to a thread 009 in Your Cars
    I will take you idea under consideration. Thanks unlike the VW tank that has a lip around the perimeter to support the tank the Subaru has none. I'm...
    200 replies | 25327 view(s)
  • Brett's Avatar
    01-10-2020, 06:26 PM
    Brett replied to a thread 009 in Your Cars
    Forgot to mention that the key fob also has the panic button feature and remote start feature on it. Update on the tank It didn't work out as...
    200 replies | 25327 view(s)
  • Brett's Avatar
    30-09-2020, 02:26 PM
    Brett replied to a thread 009 in Your Cars
    Lock/unlock feature also
    200 replies | 25327 view(s)
  • Brett's Avatar
    26-09-2020, 11:56 PM
    You can make seats with the features you want plus more. I don't expect you to build them the way I did but maybe this will give you some ideas. ...
    21 replies | 4209 view(s)
No More Results
About Brett

Basic Information

About Brett
Location:
Las Vegas,NV USA

Statistics


Total Posts
Total Posts
368
Posts Per Day
0.52
General Information
Last Activity
21-10-2020 05:50 PM
Join Date
18-11-2018
Referrals
0