Search:

Type: Posts; User: MartinB

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    23
    Views
    3,489

    Talking of hydrogen brings back some memories of...

    Talking of hydrogen brings back some memories of when we used to manufactrue a portable gas chromatography device called 'Autofim GC'; this used a hydrogen flame chamber where the ionised gas was...
  2. Replies
    14
    Views
    932

    Nice build thread... takes me back `¬)

    Nice build thread... takes me back `¬)
  3. I have a set of the 'old' Osprey restoration...

    I have a set of the 'old' Osprey restoration books, and this one was considered the fibreglass bible in its time - it contains valueble information on everything from repairs to moulds etc......
  4. Replies
    1,236
    Views
    301,517

    I also like the slightly angled upwards look `¬)...

    I also like the slightly angled upwards look `¬)

    Does the ability to see past the rear haunches have any bearing on the angles?

    Its been so long since I looked at mine, being away from it, I...
  5. Replies
    7
    Views
    531

    Isn't it strange that a large proportion of the...

    Isn't it strange that a large proportion of the population have a low level of vitamin D, especially being in lockdown and not getting sufficient sun exposure... `¬)

    I'm not convinced this is...
  6. When type iV engines were mentioned a while ago,...

    When type iV engines were mentioned a while ago, I did some searching about the type iv engine with carbs and injection fitted; On one forum (and I'm sorry I don't remember were... if I find it again...
  7. Replies
    34
    Views
    2,728

    isn't that the same product that Mikemrb posted;-...

    isn't that the same product that Mikemrb posted;-



    and I commented;-

    Looks interesting and easy, but as he comments at the end of the vid, as the solder has not penetrated the strands it...
  8. Replies
    34
    Views
    2,728

    Looks interesting and easy, but as he comments at...

    Looks interesting and easy, but as he comments at the end of the vid, as the solder has not penetrated the strands it would measure as 'continuity' but would not be good at passing current `¬)
  9. Replies
    34
    Views
    2,728

    In the photo isn't there still a weak spot where...

    In the photo isn't there still a weak spot where the copper exits the metal crimp on the wire strands? (which would be the same as if it was soldered) This would also be worse if the insulation went...
  10. Replies
    679
    Views
    111,050

    When fitting the new starter did you check /...

    When fitting the new starter did you check / replace the bush in the housing that the starter spindle fits into? I had problems with turning over many years ago and found the bush was worn on one...
  11. Replies
    75
    Views
    10,868

    try here `¬) ...

    try here `¬)

    http://www.euro-nova.co.uk/vb/showthread.php?5857-Type-4-oil-pressure-and-sounds-like


    also good source of info here for d-jet (although 914, but so similar `¬)...
  12. Replies
    75
    Views
    10,868

    Yes, definitely type IV, do you know what size it...

    Yes, definitely type IV, do you know what size it is? Do you have injection or carb?


    Same as I have in my Nova (or should I say chassis at the moment `¬)
  13. That's one very well finished car; someone has a...

    That's one very well finished car; someone has a bargain `¬)
    Surprised we haven't seen it before?
  14. Replies
    679
    Views
    111,050

    Like Brett says, re starter - check the bush that...

    Like Brett says, re starter - check the bush that the starter spindle fits into when fitting to engine, if that's worn you will have turning problems... cheap fix `¬)
  15. Replies
    23
    Views
    2,909

    I think my wiper motor and pantograph came from a...

    I think my wiper motor and pantograph came from a JCB of some sort; on the motor I think you can loosen the 'plastic' part on the motor behind the mechanism and rotate it to get the 'park' gap in the...
  16. Replies
    4
    Views
    702

    not sure what you are missing? The wiper arm is...

    not sure what you are missing? The wiper arm is driven by the motor and the other arm of the wiper pivots on the other fixed pivot point? There should be an 'insert' in the driven arm that fits onto...
  17. Thread: Eagle 2+2

    by MartinB
    Replies
    1
    Views
    465

    there was this one too... but nobody seemed...

    there was this one too... but nobody seemed interested!

    https://www.ebay.com/itm/283987315683?ul_noapp=true
  18. Replies
    0
    Views
    456

    ebay eagle shell

    https://www.ebay.com/itm/283987315683?ul_noapp=true
  19. yes, that's true!

    yes, that's true!
  20. Are you worried about cracks before the tank has...

    Are you worried about cracks before the tank has even been fitted? :scared:
  21. Replies
    1,236
    Views
    301,517

    The California mirrors are what I had before, and...

    The California mirrors are what I had before, and will probably use again; from what I remember the view was fine - I did look at other mirrors but these ones seem to suit the car... `¬)
  22. Replies
    10
    Views
    1,468

    Have you spoken to DVLA giving the reg number? ...

    Have you spoken to DVLA giving the reg number?

    When they changed the reg docs to the new colour, they never sent me one, so I rang them and explained it had been off the road before we had to...
  23. Replies
    11
    Views
    1,705

    are you sure that's not just the camera angle; I...

    are you sure that's not just the camera angle; I doubt it is flat, it would show all sorts of breaks if it was... `¬)
  24. Replies
    876
    Views
    194,994

    yes, does sound nice! `¬) The link worked ok,...

    yes, does sound nice! `¬)

    The link worked ok, but the video above the link just gives 'an error occurred'

    But yes, nice sounding Nova `¬)
  25. Replies
    876
    Views
    194,994

    ...tells me I have to log in to continue `¬( ...

    ...tells me I have to log in to continue `¬(

    (often you get a 'not now' option, but not this time!)

    What's Facebook? :coat:
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4