Page 56 of 56 FirstFirst ... 646545556
Results 551 to 556 of 556

Thread: Pog's sterling....

  1. #551
    ***Euro-Nova Supporter*** Spacenut's Avatar
    Join Date
    Jul 2007
    Location
    Hampshire, UK
    Posts
    5,339
    I've seen that type of pipe before - it's pukka hydraulic hose (I have the same type on my hydraulic throttle assembly - which is US sourced), but I have found the unions to be a weak point - they use a brass olive over the end of the pipe and then a threaded compression fitting to secure it. On two occasions now my throttle union has loosened at the master cylinder end and allowed fluid to leak out - the first time I was on my way to Stanford Hall in the Midlands, about 100 miles from home, and in the middle of a torrential downpour when I found that I could only get part-throttle with my foot to the boards! Fortunately I managed to nurse the car home before I lost all throttle travel.

    I wouldn't be surprised if the compression fitting allowed the Nylon tube to fly off under pressure Pog. So I would recommend replacement as well, I'm sorry to say.

    Lauren
    only Pythagoras can save me now!

  2. #552
    Senior Member bushboy's Avatar
    Join Date
    Jul 2007
    Location
    Grays Essex
    Posts
    2,393
    Glad that all is intact (Windscreen) for starters. God advice to use made to measure swagged fitting for the canopy. Would hurt if it hit you on the way down if it broke again.

    Bushboy
    "Always do what you are afraid to do"
    "I can accept failure, but I can't accept not trying"

  3. #553
    I have always recommended using gas struts in parallel to take the load with the hydraulics (or electrics) to move so removing the slam down if rams fail. also makes a better, smother job of moving the canopy.



    The opinions expressed in my posts may not be made in a sound mind and should be taken in the spirit intended, Jack Daniels is fine.
    Some people see things as they are and ask why? I dream things that never were and ask, why not?” JFK

    http://ukhozi.page.tl

  4. #554
    I am beginning to believe I just screwed up 10 years ago and never fully compressed this particular fitting. I was able to slide the compression piece back over the tube which should not be able to happen if properly installed in the first place. It's back on and goes up and down.

    Like I said before though I will be getting new lines made to utilize stronger fittings though.

    Hoping to get caught back up in the wiring soon and then move on to the engine!

  5. #555
    Ok, I have 0 idea where I left off with the wiring... this could be a while.

  6. #556
    Senior Member Brett's Avatar
    Join Date
    Nov 2018
    Location
    Las Vegas,NV USA
    Posts
    315
    Quote Originally Posted by vpogv View Post
    Ok, I have 0 idea where I left off with the wiring... this could be a while.
    Did you document any of it in you build diaries on the nova or sterling site??

    Or you can look for wires not connected to anything and start there

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •